Watch a short video demonstrating how to change the ejector springs in a Krieghoff K-80
Continue Reading... Comments Off on Video | Changing the Ejector Springs on a K-80In this video we look at Stock Measuring. We look at what measurements are taking, where from and how we take them. The main measurements are: Length of Pull – Centre / Heel / Toe Drop – Nose / Monte Carlo / Heel Cast – Nose / Heel / Toe Pitch – Heel / Toe […]
Continue Reading... Comments Off on Video | Stock MeasurementsIf you find yourself missing C-Clips inside your Krieghoff K-80 action, then this update to the mechanism may be of interest to you. We look at a K-80 action with and without the update and look at the differences between them.
Continue Reading... Comments Off on Video | The K-80 Side Plate UpdateIn this video we look at some methods on how to remove and attach your scope back on to a picatinny rail with better zeroing. As there are a few variations which can change slightly when remounting, the picatinny system is NOT 100% Guaranteed to repeat zero each time. But we go over some keys […]
Continue Reading... Comments Off on Video | Better Zeroing with PicatinnyWe get asked how to do this very often, so here is a short video showing you how to take the ejectors out and put them back in. Taking your barrels, give the ejectors a firm tap to free them away from the spring and ball pressure. We use the handle of the Krieghoff Stock […]
Continue Reading... Comments Off on Video | Krieghoff – Removing & Replacing the EjectorsKeeping the Barrels and Choke Tubes clean is an important job. This should ideally be done after each session. We run through some key points and steps to help keep your K-80 in good working order. We cover, cleaning the choke tubes. This involves removing them from the barrels, cleaning the choke threads and the […]
Continue Reading... Comments Off on Video | Krieghoff – Cleaning the Barrels and Choke TubesIn this video we go through the steps to remove and refit the front hanger on a K-80. With some simple tools, this job is very easy to do. With just a plastic hammer, a set of 1.4mm & 0.9mm pin punches and a wooden drift, I show you in steps, how to remove the […]
Continue Reading... Comments Off on Video | Krieghoff – Remove the Front HangerThis video cover the trigger adjustments on a Schultz & Larsen Two Stage Trigger. There are a few adjustments possible on a Two Stage Trigger and we take a look into what can be altered. There are two types of trigger on the Schultz & Larsen Victory Rifle, the Two Stage Trigger, shown in this […]
Continue Reading... Comments Off on Video | Schultz & Larsen Two Stage Trigger AdjustmentsThis video covers the trigger adjustments on the Schultz & Larsen Direct or Single Stage Trigger. You can adjust the length of pull and the weight of the trigger. ALWAYS CHECK YOUR RIFLE FOR SLAM FIRING!* * Slam Firing occurs when the the rifle goes-off when the bolt is closed. Caused by the sear engagement […]
Continue Reading... Comments Off on Video | Schultz & Larsen Direct Trigger Adjustment